Pass the CWNP CWDP Wi-Fi Design CWDP-303 Questions and answers with ExamsMirror

Your customer is using PSK as their only authentication. They have an industry requirement to move to a stronger solution. Your recommendation is to move to a certificate-based type of authentication where both the client and server require certificates. Which EAP type would be the best fit?

Using a SCA means that all APs will be using the same channel in a given layer. How is the AP with which the client associates determined?

In high-density environments, such as stadiums and convention centers, what extra factor has to be taken into account that can attenuate Wi-Fi signals when these environments are having an event?

A business traveler from North America is in Europe. The hotel only provides coverage in 2.4 GHz. The traveler connects to the hotel’s SSID and notices an AP in the hotel room. However, the laptop reports a very low RSSI when connected. The traveler does not have the same problem when connecting in the lobby. What would be the most likely cause of the low RSSI in the hotel room?

Switches and APs have already been chosen by your customer. All switches support 802.3bz MultiGig interfaces and APs are 4x4:4 802.11ac wave 2 capable of using dual-5GHz and have one MultiGig interface. Some cable drops for the APs will run for more than 180.5 feet (or 55 meters). To support MultiGig, what is the best choice of cabling?

You and 10 other people are connected to a public hotspot. You issue a ping sweep on the network, but you can’t find any devices on the same subnet as yours. What feature might be enabled on the WLAN infrastructure that is preventing you from communicating with other devices on that subnet?

When doing some frame capturing over the air during a voice call, you realized that frames on the downlink (from the AP to the client) direction are not being transmitted with the correct UP value for voice frames, but on the uplink (from the client to the AP) direction are being transmitted correctly. What’s the cause of this issue?

When installing APs on high ceilings, what should be the most common PPE to be used?

When deploying APs outdoors, what additional component needs to be used that is not needed indoors?

During a validation site survey, you realize that the installers mounted some of the APs above the ceiling. They said that this was a request from the building architect due to aesthetics constraints. During the requirements gathering, you weren’t advised about any aesthetics constraints from the main stakeholder of the project. What should you do in this case?