Pass the CWNP CWNA CWNA-107 Questions and answers with ExamsMirror

What non-standard WLAN solution attempts to give a longer transmission windows to devices with higher data rates then devise with lower data rates?

You are managing a wireless access point in autonomous mode using the Web based interface. You capture traffic during this management task and notice that you can see the HTML code of the Web pages for access point management. What error in administration could be the cause of the security concern?

The BSA of an AP covers the area used by the sales and marketing department. Thirty-five stations operate in this space. The user indicate that they need more throughput and all stations are 5 GHz capable 802.11ac clients. The current AP configuration uses 20 MHz channels in both 2.4 GHz and 5 GHz. What is the least expensive solution available for increasing throughput for these users without implementing configuration options that are not recommended?

A natural disaster has occurred in a remote area that is approximately 40 miles from the response team headquarters. The response team must setup a local wireless network using 802.11 WLAN access points. What is the best method, of those listed, for implementation of network backhaul for communications across the Internet in this scenario?

You are evaluating access points for use in the 5GHz frequency band. What PHY supports this band and supports 80 MHz channels?

Which IEEE 802.11 physical layer (PHY) specification includes support for and compatibility with both ERP and HR/DSSS?

What is the most effective method of testing roaming in relation to 802.11 VoIP handsets?

A non-802.11 device is suspected of causing interference on the WLAN. You are not certain of the location or type of device. What is the best solution for locating this non-802.11 device?

Return Loss is the decrease of forward energy in a system when some of the power is being reflected back toward the transmitter.

What will cause high return loss in an RF transmission system, including the radio, cables, connectors and antenna?

You are troubleshooting a controller-based AP that is unable to locate the controller. DHCP is not use and the controller is located at 10.10.10.81/24 while the AP is on the 10.10.16.0/24 network. What should be inspected to verify proper configuration?