Spring Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = getmirror

Pass the EMC DECS-IE DES-1721 Questions and answers with ExamsMirror

Practice at least 50% of the questions to maximize your chances of passing.
Exam DES-1721 Premium Access

View all detail and faqs for the DES-1721 exam


797 Students Passed

90% Average Score

95% Same Questions
Viewing page 2 out of 5 pages
Viewing questions 11-20 out of questions
Questions # 11:

You are implementing a front-end connection in Legacy Port Mode on an SC4020 in a SAN with two iSCSI switches. What is the minimum number of port(s), per switch, that can be used by the SC Series array?

Options:

A.

One port on each of the Ethernet switches

B.

Two ports on each of the Ethernet switches

C.

Four ports on each of the Ethernet switches

D.

Eight ports on each of the Ethernet switches

Questions # 12:

What is the recommended minimum number of ports per controller, per fault domain, to support port-level failover?

Options:

A.

1

B.

2

C.

3

D.

4

Questions # 13:

Refer to the exhibits.

Which is the correct front end and cabling for an SC7020 with 2 port FC connectivity?

A)

Question # 13

B)

Question # 13

C)

Question # 13

D)

Question # 13

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Questions # 14:

Which 64-bit server operating systems are compatible with the Dell Storage Manager (DSM) Client?

Options:

A.

Red Hat Enterprise Linux 6, Windows Server 2012 R2, and Windows Server 2008 R2

B.

Windows Server 2008 R2, Windows Server 2012 R2, and Windows 2016

C.

Windows Server 2008 R2, Red Hat Enterprise Linux 7, and Windows Server 2012 R2

D.

Red Hat Enterprise Linux 6, Windows Server 2016, and Windows Server 2008 R2

Questions # 15:

You are implementing a front-end connection in Legacy Port Mode on an SC4020 in a SAN with two iSCSI switches. What is the minimum number of port(s), per switch, that can be used by each controller?

Options:

A.

One port on each Ethernet switch

B.

Two ports on each Ethernet switch

C.

Four ports on each Ethernet switch

D.

Eight ports on each Ethernet switch

Questions # 16:

An administrator wants to configure an SC Series array to use Virtual Port Mode. What is a requirement to accomplish this task?

Options:

A.

NPIV must be disabled on Fibre Channel switches

B.

I/O Controller cards must use a single-ID firmware version

C.

Fibre Channel switches must use a switched fabric topology

D.

Activation license must be purchased and installed

Questions # 17:

Why should Legacy Port Mode be selected rather than Virtual Port Mode on an SC Series storage array?

Options:

A.

Virtual Port Mode requires NPIV support

B.

Legacy Port Mode is easier to set up and more reliable

C.

Virtual Port Mode is difficult to set up

D.

Virtual Port Mode does not support ALUA

Questions # 18:

Refer to the Exhibit.

Question # 18

A customer has asked you to perform a port failover test to demonstrate system resiliency. What is needed to complete this task?

Options:

A.

Add more cables per switch

B.

Switch to Legacy Port Mode

C.

Add more switches per controller

D.

Switch to Virtual Port Mode

Questions # 19:

A customer is concerned they are over utilizing their 7K drives. Where can information about the real time I/O usage of individual drives be viewed?

Options:

A.

Hardware > Disks > [disk folder] > [disk number]

B.

Charting > Disks > [disk folder] IO Charts

C.

Charting > Disks > [disk folder] > [disk number]

D.

Hardware > Disks > [disk folder]

Questions # 20:

Which command is used to set the eth0 IP address on an SC4020 controller?

Options:

A.

ifconfig inet eth0 [IP address] [netmask] [gateway]

B.

controller ipconfig eth0 [IP address/prefix length]

C.

ifconfig inet eth0 [IP address/prefix length]

D.

controller ipconfig eth0 [IP address] [netmask] [gateway]

Viewing page 2 out of 5 pages
Viewing questions 11-20 out of questions
TOP CODES

TOP CODES

Top selling exam codes in the certification world, popular, in demand and updated to help you pass on the first try.