Summer Certification Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = getmirror

Home
DELL EMC
EMC Certification
E20-375
RecoverPoint Specialist Exam for Implementation Engineers Questions and Answers

Pass the DELL EMC EMC Certification E20-375 Questions and answers with ExamsMirror

Practice at least 50% of the questions to maximize your chances of passing.

Exam E20-375 Premium Access

View all detail and faqs for the E20-375 exam

Go to Exam

807 Students Passed

88% Average Score

96% Same Questions

Viewing page 3 out of 6 pages

Viewing questions 21-30 out of questions

Questions # 21:

An application team will be performing a major update to a RecoverPoint protected application. You have been asked by the application team for the best way to ensure a quick recovery at the remote cluster in case the update fails.

In RecoverPoint, what should be done to the associated Consistency Group?

Options:

Manually create a bookmark prior to the update

Enable logged access mode on the source

Enable physical access on the target

Use virtual access mode on the source

Answer

Questions # 22:

A customer is evaluating the deployment of RecoverPoint with their VNX array. They want to deploy the RPAs in virtual appliance form. They ask your opinion about using vRPA versus physical appliances.

What should you advise them?

Options:

They cannot mix physical and virtual RPAs within their RPA cluster.

For performance reasons, they can mix vRPAs and physical RPAs in the remote RPA cluster.

vRPAs cannot be used in a VNX environment.

They can mix vRPA and physical RPAs in the same RPA cluster at all sites.

Answer

Questions # 23:

A Consistency Group is experiencing High Load twice a day in a RecoverPoint remote replication environment.

What is a possible reason for the High Load to occur on the Consistency Group?

Options:

Slow-performing journal volume at the remote copy cluster

Large amount of reads coming from the local source volumes

Slow-performing repository at the local cluster

Slow-performing repository at the remote cluster

Answer

Questions # 24:

An administrator experiences a serious error with an RPA and calls EMC Support to resolve the issue. They are concerned that the system did not automatically notify EMC Support via the ESRS gateway. You check all settings in Unisphere Configure System Notification and find they are correct.

What is the most likely cause for this notification failure?

Options:

TCP port 25 blocked at their firewall

TCP port 989 blocked at their firewall

TCP port 990 blocked at their firewall

Temporary remote support license key expired

Answer

Questions # 25:

Refer to the exhibit.

Question # 25

A customer is implementing a RecoverPoint solution with a two-node cluster. What is represented by the 'A' in the exhibit?

Options:

WAN

LAN

iSCSI

Floating IP

Answer

Questions # 26:

A storage administrator is installing the VSI RecoverPoint Management plug-in, but the installation fails.

What could be causing this?

Options:

vSphere client not installed

vSphere client not running during the installation

RPAs used were all virtual

At least one virtual RPA present

Answer

Questions # 27:

Which tool do you need in order to run the save_settings command from a Windows command prompt?

Options:

PLink

PuTTY

CuteFTP

WinSCP

Answer

Questions # 28:

How much data, at a minimum, must change in order for the snapshot consolidation process to start?

Options:

64 MB

128 MB

512 MB

1 GB

Answer

Questions # 29:

You are protecting a volume using the wizard in Unisphere for RecoverPoint. Which state will the new Consistency Group be in immediately after completing the wizard?