VPLEX Specialist Exam for Storage Administrators (E20-562) Practice Test

Questions # 11:

What steps are performed during extent and device migration?

Options:

Start, commit, clean, and remove

Start, commit, clean, and terminate

Create, commit, clean, and terminate

Create, clean, commit, and remove

Questions # 12:

Which protocol does the service laptop use to communicate with and maintain an EMC VPLEX environment?

Options:

SSH

SNMP

Telnet

UDP

Questions # 13:

What is a feature of GeoSynchrony 6.0 with respect to service account login to the VPlexcli?

Options:

Service account requires authentication to the Linux shellVPlexcli requires an RSA token

Service account requires no authentication to the Linux shellVPlexcli requires certificate authority

Service account requires no authentication to the Linux shellVPlexcli requires authentication through LDAP

Service account requires authentication only to the Linux shellVPlexcli does not require an extra authentication step

Questions # 14:

LUNs are being provisioned from an ALUA-capable back-end array to VPLEX. What is the path requirement for each VPLEX director when connecting to this type of array?

Options:

At least two paths to every back-end array and storage volume

At least two paths to both the active and passive array controllers

A least two paths to both the active and non-preferred array controllers

At least two paths to the active array controller only

Questions # 15:

What is the correct order of steps to create a virtual volume?

Question # 15

Options:

Questions # 16:

What is required to add a RecoverPoint cluster to VPLEX?

Options:

RecoverPoint cluster ID

RecoverPoint cluster name

RecoverPoint cluster Management IP address

RecoverPoint cluster license number

Questions # 17:

Using the Storage Volume expansion method for virtual volumes built on RAID-1 or distributed RAID-1 devices, what is the maximum number of initialization processes that can run concurrently, per cluster?

Options:

100

250

500

1000

Questions # 18:

Which command can be used to create a distributed virtual volume from specified storage volumes?

Options:

storage-tool compose

ds dd create

virtual- volume create

storage-volume compose

Questions # 19:

What is required before a host can detect the virtual volumes presented by the VPLEX?

Options:

Virtual volumes can only be detected after a reboot

RAID configuration must be enabled for Virtual volumes

EZ Provisioning wizard must be run on the host

Host must initiate a bus-scan of the HBAs

Viewing page 2 out of 2 pages

Viewing questions 11-20 out of questions

Spring Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = getmirror

Pass the EMCSA VPLEX E20-562 Questions and answers with ExamsMirror

Exam E20-562 Premium Access

Options:

Options:

Options:

Options:

Options:

Options:

Options:

Options:

Options:

TOP CODES