Summer Certification Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = getmirror

Home
F5
F5-CA
201
TMOS Administration Questions and Answers

Pass the F5-CA 201 Questions and answers with ExamsMirror

Practice at least 50% of the questions to maximize your chances of passing.

Exam 201 Premium Access

View all detail and faqs for the 201 exam

Go to Exam

809 Students Passed

93% Average Score

93% Same Questions

Viewing page 5 out of 8 pages

Viewing questions 41-50 out of questions

Questions # 41:

Assume a client's traffic is being processed only by a NAT; no SNAT or virtual server processing takes place. Also assume that the NAT definition specifies a NAT address and an origin address while all other settings are

left at their defaults. If the origin server were to initiate traffic via the BIG-IP, what changes, if any, would take place when the BIG-IP processes such packets?

Options:

The BIG-IP would drop the request since the traffic didn’t arrive destined to the NAT address.

The source address would not change, but the destination address would be changed to the NAT address.

The source address would be changed to the NAT address and destination address would be left unchanged.

The source address would not change, but the destination address would be changed to a self-IP of the BIG-IP.

Answer

Questions # 42:

Which parameters are set to the same value when a pair of BIG-IP devices are synchronized?

Options:

host names

system clocks

profile definitions

VLAN failsafe settings

MAC masquerade addresses

Answer

Questions # 43:

Refer to the exhibit.

Question # 43

How are new connections load balanced?

Options:

To the first two members listed with the same priority group

To the pool member with the least number of connections

To the pool member with a high priority group value defined

To the pool member with a low priority group value defined

Answer

Questions # 44:

The BIG-IP Administrator needs to perform a BIG-IP device upgrade to the latest version of TMOS. Where can the administrator obtain F5 documentation on upgrade requirements?

Options:

AskF5

DevCentral

Bug Tracker

iHealth

Answer

Questions # 45:

A BIG-IP Administrator applied the latest hotfix to an inactive boot location by mistake, and needs to downgrade back to the previous hotfix.

What should the BIG-IP Administrator do to change the boot location to the previous hotfix?

Options:

Uninstall the newest hotfix and reinstall the previous hotfix

Reinstall the base version and install the previous hotfix

Reinstall the previous hotfix and re-activate the license

Uninstall the base version and restore the UCS

Answer

Questions # 46:

A BIG-IP Administrator uses a device group to share the workload and needs to perform service on a BIG-IP device currently active for a traffic group. The administrator needs to enable the traffic group to run on another BIG-IP device in the device group. What should the administrator do to meet the requirement?

Options:

Create a new Traffic Group and then fail to Standby Unit

Select Traffic Group and then select Failover

Select Traffic Group and then select Force to Standby

Select Traffic Group on Primary Unit and then select Demote

Answer

Questions # 47:

Refer to the exhibit.

Question # 47

A user attempts to connect to 10.10.10.1.80 using FTP over SSL with an FTPS client. Which virtual server will match and attempt to process the request?

Options:

vsjutps

vs_ftp

vs_http

nvfs

Answer

Questions # 48:

Users report that traffic is negatively affected every time a BIG-IP device fails over. The traffic becomes

stabilized after a few minutes.

What should the BIG-IP Administrator do to reduce the impact of future failovers?

Options:

Enable Failover Multicast Configuration

Set up Failover Method to HA Order

Configure MAC Masquerade

Configure a global SNAT Listener

Answer

Questions # 49:

The BIG-IP Administrator needs to ensure the correct health monitor is being used lor a new HTTP pool

named P_example.

Where should the BIG-IP Administrator validate these settings in the Configuration Utility?

Options:

Local Traffic > Nodes > Default Monitor

Local Traffic > Profiles > Services > HTTP > http

Local Traffic > Monitors > http

Local Traffic > Pools > P_ example

Answer

Questions # 50:

Refer to the exhibit.

Question # 50

Due to a change in application requirements, a BIG-IP Administrator needs to modify the configuration of a Virtual Server to include a Fallback Persistence Profile.

Which persistence profile type should the BIG-IP Administrator use for this purpose?