Pass the Huawei HCSP Presales H19-424_V1.0 Questions and answers with ExamsMirror

For the Locator CIDR block planning of SRv6, the appropriate mask should be set according to the number of IPv6 SIDs that may be used by the device.

loatos svV6_locator ipu6-prelix21.DB8ABCD: .b4 static 32, Locator is 2001.DB8.ABCD:, length 64 bits, static segment occupies 32 bits, dynamic segment occupies 32 bits args field occupies O bits. The starting value of the state segment is: 2001:DB8:ABCD:0000:0000:0000:C

Locator SID supports static configuration or dynamic allocation, end-op and end-m must be statically configured, and static configuration is also recommended for end and end.x, which is convenient for network O&M. Other SIDs can be assigned dynamically.

Devices at the same site belong to the same large network segment with the same prefix, and different devices are assigned to the small network segment with the same prefix in the large network segment.

Synchronize information between dual-gateway devices through the interlink control sub-interface, such as the synchronization and backup of application recognition results, overlay connection information, and connection quality information. Interlink serves as a dual-gateway device interconnection interface that forwards inter-device (VPN) traffic through sub-interfaces.

Interlink serves as a dual-gateway device interconnection interface, providing forwarding of inter-device service (VPN) traffic through sub-interfaces.

Interlink can be interconnected with a direct link, and when the site service traffic is large and the CPE port resources are sufficient, it is recommended that Interlink use an Eth-trunk link. Interlink cannot borrow Layer 2 service interfaces on the CPELAN side.

Interlink cannot borrow the Layer 2 service interface on the CPE LAN side

IGP

CLI/Netconf/yang

BGP

PCEP

Scan phase (SCAN)

Link Authentication

Access authentication

Key negotiation

Provide wireless terminal access function

Establish a MESH connection

Each radio can be configured with multiple radio resources, and the number is unlimited

Each radio can be configured with only one

04, 06, and 10 main control boards cannot be shared

The main controller does not provide a business port

The main control and switching are integrated, and the centralized architecture has a lower switching delay

1:1 primary/standby in the frame, primary/standby switchover and packet loss < 5ms

Router Node

FW Node

Border Node

Edge Node

The logical networking initialization diagram is determined by the parameters of the scenario of the solution

Support multi-region, multi-aggregation node design

The working mode supports stand-alone and stacked

You can't manually drag and drop to modify

CloudEngine S series switches

CE series switches in data centers

WLAN AP

AR series routers

USG series firewalls