Pass the Nutanix Certified Associate (NCA) NCA-5.20 Questions and answers with ExamsMirror

An application owner had reported that an AHV-based critical application VM is performing very slowly. After initial diagnostics, it has been observed that the CPU utilization is significantly higher than normal.

What two actions should the administrator take on this VM without shutting it down? (Choose two.)

A mission critical application with four VMs have been deployed inside of a six-node Nutanix cluster. An alert is generated that a node in the cluster has failed and is no longer online. After the alert, two of the VMs reboot and come back online on another node.

Which feature, when configured, would have prevented the two VMs from rebooting?

An administrator needs to provide data integrity at the application level for a VM that is replicated to a secondary site. Which requirement will satisfy this task?

Refer to the exhibit.

An administrator has configured Prism Central to email daily digests of alerts on a cluster. After a week, the administrator notices that digests are not being received.

What is the most likely cause of the issue?

After adding a remote site cluster, an administrator must map which two entities? (Choose two.)

A developer requests that a VM connects to a block device from an older ISCSI disk array, in order to support an application being transitioned to Nutanix.

What should the Nutanix administrator do to complete this task?

An administrator wants a VM to communicate with two separate VLANs. What steps should the administrator complete?

Refer to the exhibit.

What is indicated by the yellow area of the chart?

Refer to the exhibit.

A team member has built a CentOS VM image for use as a template. An administrator deploys a new VM using the CentOS image as the 05 drive. No other drives are presented to the VM.

Following the deployment, the administrator attempts to boot the VM, but is unsuccessful.

What could be causing this issue?

Which option allows administrators to specify groups of VMs and assign them to a destination for Disaster Recovery using Leap?