Pass the Nutanix NCM-MCI NCM-MCI-5.20 Questions and answers with ExamsMirror

The following critical Availability Alert displays in prism Central:

The protection Policy PP-BCA-1HR includes a business critical application with a 1-hour snapshot frequency.

What is causing this issue?

A VM does not have enough resources for the demand, which leads to performance bottlenecks. The VM is exhibiting one or more of following baseline values, based on the past 30 days:

• CPU usage > 90% (moderate), 95% (high)

• CPU ready time > 5%, 10%

• Memory usage > 90%, 95%

• Memory swap rate > 0 Kbps (no moderate value)

Which type of VM is being described?

An administrator needs to make sure an RF3 cluster can survive a failure of two complete racks without negatively affecting performance. The current cluster configuration consists of the following:

• 30 All Flash Nodes: distributed 10 nodes per rack across three 42U racks

• Each node is configured with 20TB usable storage all flash (Cluster Total 600TB Usable)

• Current cluster utilization is 500TB storage

• Storage containers have Erasure Coding enabled

Which configuration changes should be made to make sure the cluster meets the requirements?

An administrator is deploying an application using Nutanix Volumes. After configuring the volume group and connecting the guest's iSCSI initiator to the volume group, they begin performance testing.

The administrator learns that performance on the virtual disk attached to the iSCSI initiator is far less than that of a virtual disk connected directly to the VM.

Which situation is causing this condition?

An administrator needs to expand a nutanix cluster that is tagging the network traffic at the CVM and AHV level, however the administrator doesn't remember the configured VLAN ID.

Which AHV command can the administrator run to find the correct VLAN ID?

Refer to the exhibit.

An administrator has configured Prism Central to email daily digest of alerts on a cluster, after a week, administrator notices that digests are not being received.

What is the most likely cause of the issue?

An administrator needs to deploy an application with a large amount of data connected via Nutanix Volumes.

Which two actions should the administrator take when designing the Volume Group? (Choose two.)

An administrator configures authentication in Prism Central (PC) for the NTNX-Admins group. Users report that they are unable to log in. The administrator confirms that the Active Directory (AD) settings in PC are correct.

Which condition could result in this behavior?

An administrator receives an alert in Prism indicating that interface eth2, on an AHV host is receiving many CRC errors. After togging into the problematic host, the following command is run to show the indicated output:

What is causing this issue?

In an AHV cluster, an administrator needs to enable an application to share a disk b group but needs to enable the VMs to see the volume group.

How should the administrator accomplish this task?