Pass the Pure Storage FlashArray Storage FlashArray-Storage-Professional Questions and answers with ExamsMirror

In the Pure Storage FlashArray GUI, granular performance metrics (Latency, IOPS, Bandwidth) are located under the Analysis > Performance tabs. When you navigate to the Volumes sub-tab and select a specific volume, Purity displays a unified line graph tracking the performance of that volume over time.

By default, the Latency graph simultaneously plots Read , Write , and Mirrored Write (for volumes participating in an ActiveCluster or synchronous replication pod) latencies. Because these lines can overlap or compress the Y-axis (especially if one metric spikes), isolating a specific metric requires interacting with the graph ' s legend.

To view the exact, un-obscured latency for standard write requests to that volume, the administrator should click on " Read " and " Mirrored Write " in the chart ' s legend. This deselects those metrics, effectively hiding their lines from the graph and automatically rescaling the view to exclusively display the host write latency.

Here is why the other options are incorrect:

Health > Network (A): The Health tab is used to check the hardware status of the physical controller ports, including link state and errors. While you might see port-level throughput or queue depth here, it does not provide volume-specific application latency.

Storage > Volumes > Details (B): The Storage tab is primarily used for provisioning and configuration management. Clicking on a volume here will show its size, data reduction ratio, snapshot policies, and connected hosts, but it does not provide detailed interactive performance graphs.

On the Pure Storage FlashArray//C R4 (as well as the //XL and //E series architectures), the onboard 100Gb/s Ethernet LOM (LAN on Motherboard) ports—specifically eth0 and eth1—are purpose-built and strictly reserved for DirectFlash Shelf (DFS) connectivity .

Pure Storage uses these dedicated 100GbE ports to run NVMe over RoCE (RDMA over Converged Ethernet), effectively extending the array ' s internal PCIe backplane to additional backend storage shelves. Because these ports are hardcoded exclusively for back-end shelf expansion, the Purity operating environment fundamentally restricts them from being assigned IP addresses for front-end host I/O services. Therefore, an administrator will be completely unable to configure eth0 or eth1 for iSCSI, NVMe/TCP, or Replication. Front-end iSCSI services must instead be configured on the dedicated Host I/O PCIe cards (which typically appear as eth2, eth3, etc., depending on the slot configuration).

Here is why the other options are incorrect:

The ports are designated for Management connectivity (A): On modern FlashArrays, dedicated management ports are typically out-of-band 1GbE/10GbE RJ45 ports (often designated as vir0 or specific management eth ports on older hardware), not the ultra-high-speed 100Gb/s QSFP28 ports.

The DAC cables are not compatible with the array ' s ports (B): While incompatible cables can prevent a link from coming up physically, the specific reason the administrator cannot configure the ports for iSCSI in the Purity software is due to the port ' s hardcoded role (DFS), not the physical cable type.