Weekend Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = simple70

Pass the VMware VCAP-NV Design 2020 3V0-42.20 Questions and answers with ExamsMirror

Practice at least 50% of the questions to maximize your chances of passing.

Exam 3V0-42.20 Premium Access

View all detail and faqs for the 3V0-42.20 exam

Go to Exam

405 Students Passed

96% Average Score

95% Same Questions

Viewing page 1 out of 2 pages

Viewing questions 1-10 out of questions

Questions # 1:

An administrator is asked to improve Recovery Point Objective (RPO) and Recovery Time Objective (RTO) for Disaster Recovery (DR) in their company network. The network has a primary site and a secondary site. The ability to support outages with minimum loss of connectivity to the company’s core application is a priority.

Which design should the administrator recommend? (Choose the best answer.)

Options:

NSX-T Data Center using an Orchestrator to recover VMs across sites.

NSX-T Data Center using Federation and dependencies set between primary and secondary sites.

NSX-T Data Center using a registered third-party DR solution.

NSX-T Data Center using built-in standard automation DR and secondary site recovery setup.

Questions # 2:

A Solution Architect will be deploying an Ethernet Virtual Private Network (EVPN) in their NSX-T Data Center environment.

What two selections must be prepared for the EVPN deployment? (Choose two.)

Options:

deployed Tier-0 gateway

deployed Load Balancer

deployed Tier-1 gateway

remote gateway with support for IGP and VLAN priority

remote gateway with support for MP-BGP and VXLAN

Questions # 3:

A telecom company has purchased NSX-T as part of a Software Defined Data Center (SDDC) initiative. The company wants to ensure the highest performance for network traffic leaving the virtual environment.

Options:

Configure Equal-Cost Multi-Pathing on the NSX Edges.

Configure SR-IOV for the virtual NSX Edges.

Use bare metal NSX Edges.

Select Network cards that support VXLAN Offload.

Set “Latency Sensitive” option to High when deploying the virtual NSX Edges.

Questions # 4:

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.

This information was gathered during the assessment:

There must be a performance based SLA for East – West traffic.

Which two key performance features should the architect recommend? (Choose two.)

Options:

Configure N-VDS enhanced Data Path

Install advanced Edge pNIC Features

Setup RSS to leverage multiple cores

Leverage DPDK drivers

Enable GENEVE Offload

Questions # 5:

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.Which two statements should the architect consider as non-technical requirements? (Choose two.)

Options:

Any solution should add more value to current and future customers engagements.

The design should offer agility and freedom for application phases.

All application servers have hardcoded IP addresses.

Current business continuity and disaster recovery plans are based on tape technology.

Different vendors are used for the storage solution.

Questions # 6:

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.

This information was gathered during the Assessment Phase:

Data between two networks connected over a public network needs to be encrypted.

Certificate authentication is required.

Dynamic route learning is preferred.

Which selection should the architect include in their design? (Choose the best answer.)

Options:

Deploy a Tier-0 gateway in Active/Standby mode. Configure policy-based IPSec VPN with SHA512 with RSA as the hash algorithm.

Deploy a Tier-0 gateway in Active/Active mode. Configure route-based IPSec VPN with SHA512 with RSA as the hash algorithm.

Deploy a Tier-0 gateway in Active/Standby mode. Configure route-based IPSec VPN with SHA512 with RSA as the hash algorithm.

Deploy a Tier-0 gateway in Active/Active mode. Configure policy-based IPSec VPN with SHA512 with RSA as the hash algorithm.

Questions # 7:

Which selection must be taken into consideration when creating a Logical Design for a planned migration? (Choose the best answer.)

Options:

An N-VDS can only attach to a single Overlay transport zone.

An N-VDS can only attach to a single VLAN transport zone.

An N-VDS can attach to both an Overlay and a VLAN transport zone to a N-VDS having different name/s.

An N-VDS must be disabled before attaching both Overlay and VLAN transport zones.

Questions # 8:

Which two benefits can be achieved using in-band management of an NSX Bare Metal Edge Node? (Choose two.)

Options:

Reduces storage requirements.

Reduces cost.

Preserves packet locality.

Reduces egress data.

Preserves switchports.

Questions # 9:

An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution.

Which risk is documented by an architect? (Choose the best answer.)

Options:

The security team has a firewall communication matrix documented.

The team is not trained for NSX-T but have a very strong experience with vSphere.

Open communication between different application tiers is not allowed.

Aggregate N-S throughput at any given time should be at least 10G.

Questions # 10:

Which two VMware recommendations should an architect follow when configuring top of rack (ToR) switches in an NSX-T Data Center environment? (Choose two.)