Pass the Cisco CCNP Enterprise 300-420 Questions and answers with ExamsMirror

Drag and drop the components in a Cisco SD-Access architecture from the left onto their descriptions on the right.

Refer to the exhibit. An architect must design a solution to connect the two ASs. To optimize bandwidth, the design will implement load sharing between router R6 and router R4. Which solution should the design include?

In a Cisco SD-Access fabric, switch node Is equivalent to an access layer switch In a traditional three-tier campus network design?

An engineer is designing an enterprise campus network. The LAN infrastructure consists of switches from multiple vendors, and Spanning Tree must be used as a Layer 2 loop prevention mechanism. All configured

VLANs must be grouped in two SIP instances. Which standards-based Spanning Tree technology supports this design solution?

An engineer must use YANG with an XML representation to configure a Cisco IOS XE switch with these specifications:

IP address 10.10.10.10/27 configured on the interface GigabitEthernet2/1/0

connectivity from a directly connected host 10.10.10.1/27

Which YANG data model set must the engineer choose?

A)

B)

C)

D)

What does the fabric data plane leverage in SD-Access Architecture?

A customer with an IPv4 only network topology wants to enable IPv6 connectivity while preserving the IPv4 topology services. The customer plans to migrate IPv4 services to the IPv6 topology, then decommission the IPv4 topology. Which topology supports these requirements?

When vEdge router redundancy is designed, which FHRP is supported?

Drag and drop the Cisco SD-WAN components from the left onto their definitions on the right.

An engineer uses Postman and YANG to configure a router with:

Which get-config replay verifies that the model set was designed correctly?