Pass the Cisco CCNP Enterprise 300-420 Questions and answers with ExamsMirror

A customer requests a VPN solution to connect multiple sites with the company headquarters. All the sites use the same IP subnet. The engineer plans to use VPLS. Which solutions must the engineer include in the design?

An engineer uses Postman and YANG to configure a router with:

OSPF process ID 200

network 172.16.10.128/26 enabled for Area 0

Which get-config reply verifies that the model set was designed correctly?

Refer to the exhibit. An architect with an employee ID: 4542:60:170 is designing a campus Layer 2 infrastructure. The design requires a PoE power budget that varies from 30-60 W. In addition, power must be provided continuously to some endpoints and must be supported even during the reloading of edge switches. Which solution must the architect select?

An architect is designing a network solution for a customer The network is IPv6-only with 1000 hosts. The design must provide external access to up to 10 concurrent IPv6 hosts to allow communication with legacy IPv4 devices on an adjacent network. The customer set aside 10 IPv4 addresses to allow for one-to-one communication between hosts. Which solution must the architect select?

An architect is designing how the company will manage the infrastructure of a large data center. The company wants to group device types for security reasons and mitigate DoS attacks. The company also wants to ensure that access to the rest of the production network is not possible if one device is compromised on the management plane. Which solution must the architect choose?

Refer to the exhibit. An architect is designing an ISIS solution with these requirements:

The backbone area will grow to 50 routers in the next 12 months.

Routers A1 and A2 must avoid suboptimal routing.

Summarization and route-leaking should be allowed in areas 49.002 and 49.003.

Which solution must the architect select?

In PIM sparse mode, if an RPF check is successful on a multicast-enabled device, what happens to the multicast packet?

In Cisco SD-Access. virtual networks create segmentation that allows for separation of users and resources. How is this type of segmentation described?

Refer to the exhibit.

Which solution decreases the EIGRP convergence time?

Refer to the exhibit. A network engineer must design a highly available OSPF solution based on these requirements:

Traffic disruptions caused by link or node failures in Area-1 must be resolved in milliseconds.

In the event of a failure, traffic must switch to another path without waiting for the OSPF dead interval.

Which fault detection solution must the engineer choose?