Pass the Cisco CCNP Enterprise 300-420 Questions and answers with ExamsMirror

Refer to the exhibit. An architect must ensure a convergence time of 200 ms or less during a link failure within area 0. In addition, the solution must not impact the overall performance of the network. Which solution must the architect select?

A company plans to transition to IPv6. They will link their IPv4 addresses to the lowest significant bits of the new Ipv6 addresses. A network administrator with an employee id: 4264:42:116 is preparing a mapping schema for the new IPv6 addresses. Which address does the 172.16.10.0/24 network translate to?

What is one function of the vSmart controller in an SD-WAN deployment?

Refer to the exhibit. An engineer is designing an OSPF network for a client. Requirements dictate that the routers in Area 1 should receive all routes belonging to the network, including EIGRP, except the ones originated in the RIP domain. Which action should the engineer take?

Refer to the exhibit. An architect must design an IP addressing scheme for a multisite network connected via a WAN transit. The campus site must accommodate 12,000 devices and the branch sites must accommodate 1,000 devices. Which address scheme optimizes network device resources, contains convergence events to the different blocks of the network, and ensures future growth of the network?

Refer to the exhibit. A network architect is preparing a network design based on the EIGRR Routers are connected using a cat6a cable type and the inter-router connection speed is limited to 10 Mbps due to distance. During the pilot phase, a DUAL-3-SIA error message is visible. Which action must the engineer take to create a stable design?

An architect must address sustained congestion on the access and distribution uplink of network. QoS has already been implemented and optimized, but it is no longer effective in ensuring optimal network performance. Which two solutions should the architect use to improver network performance? (Choose two)

Which function are fabric intermediate nodes responsible for in an SD-Access Architecture?

A customer plans to deploy WoL in the enterprise with these high-level design requirements:

Which two solutions must the customer select to have a successful deployment? (Choose two.) 3 A. IP directed broadcast and forward-protocol must be enabled on all the SVI or routed interlaces where the client subnets reside.

B. IP helper-addresses for the client ranges must be enabled on the SVI or routed interface where the WoL server subnet resides.

C. IP helper-addresses for the client ranges must be disabled on the SVI or routed interface where the WoL server subnet resides

D. IP helper-addresses for the WoL server must be enabled on the SVI or routed interface where the client subnets reside

E. IP directed broadcast and forward-protocol must be disabled on all the SVI or routed interfaces where the client subnets reside.

Which two LISP components are required in the Cisco SD-Access fabric control plane node? (Choose two.)