Pass the Cisco CCNP Service Provider 300-510 Questions and answers with ExamsMirror

Refer to the exhibit.

All routers on this network have been configured with P1M-SM and R1 is the rendezvous point However, when asymmetric routing is implemented to modify link usage the network begins to drop certain multicast traffic Which action corrects the problem?

STION NO: 82

Refer to the exhibit.

After maintenance to activate BGP neighbors connecting a new data center attached to R1,

L3VPN customers attached to OSPF domain 100 lost connectivity to services in OSPF 200 and OSPF 300 However Unified MPLS services within OSPF 100 remain reachable Which action must the network engineer take to resolve the outage?

See the solution below in Explanation.

Refer to the exhibit. An engineer is troubleshooting an issue with traffic steering using the color-only automated steering mechanism. BGP is failing to automatically steer traffic into an SR policy with the given color of a route, regardless of the next hop. The layer 2 configuration is correct, and the physical connection between the devices is working normally. Whch additional command sequence must the engineer add to correct the issue?

Drag and drop the characteristics from the left onto the corresponding routing protocols on the right.

What Is a characteristic of a segment routing mapping server?

Refer to the exhibit.

Customer traffic from the branch site to the hub is experiencing packet drops. The engineer verified that:

Customer traffic from the hub is able to reach the branch site.

The connection between PE1 and PE2 is working normally.

Routers P1 and P2 are able to ping devices on the hub site.

Which action resolves the issue?

Refer to the exhibit.

The four routers in this network have formed adjacencies. Router R2 is an IS-IS level 1-2 router that connects to other areas, and the attach bit is set in the R2 level 1 LSP advertisements to R1. According to the network design, R2 should push level 2 routes from its routing table to the R1 routing table. However, R1 installed a default route in its routing table. Which action resolves this problem?

Refer to the exhibit.

A network engineer must enable segment routing between the three autonomous systems with these requirements:

·OSPF link-state data for area 0 routers must be distributed to the controller via BGP LS.

·EPE must be enabled on the egress node in AS 100.

·Routers must advertise peer node SIDs to the controller R1 via BGP LS.

Which configuration must the engineer apply?

A)

B)

C)

D)

NO: 93

Which fact must a network architect consider when implementing IGMP in a multicast routing environment?