Summer Certification Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = getmirror

Home
Cisco
CCNP Data Center
350-601
Implementing Cisco Data Center Core Technologies v1.1 (350-601 DCCOR) Questions and Answers

Pass the Cisco CCNP Data Center 350-601 Questions and answers with ExamsMirror

Practice at least 50% of the questions to maximize your chances of passing.

Exam 350-601 Premium Access

View all detail and faqs for the 350-601 exam

Go to Exam

811 Students Passed

84% Average Score

92% Same Questions

Viewing page 5 out of 13 pages

Viewing questions 41-50 out of questions

Questions # 41:

The Cisco Nexus 5600 Series Switch experiences occasional packet drops on interface ethernet 1/16. An engineer wants to implement a SPAN session to investigate the issue further. The network analyzer to which the packets must be directed is located on interface 1/3. The analyzer is limited on disk space available for traffic capture, so the Nexus switch should send only the relevant data. Which two command sets configure the SPAN session that meets these requirements? (Choose two.)

Question # 41

Options:

Option A

Option B

Option C

Option D

Option E

Answer

A, E

Questions # 42:

Refer to the exhibit.

Question # 42

Cisco Fabric Services is enabled in the network. Which type of IP address is used by the Cisco Fabric Services protocol?

Options:

IPv4 unicast address

IPv4 multicast address

IPv4 gateway address

IPv4 anycast address

Answer

Questions # 43:

Which Cisco UCS firmware reboot policy must be used in the maintenance policy to prevent the server firmware from upgrading automatically and wait for user input before proceeding?

Options:

Immediate

Schedule

User-ack

Timer-automatic

Answer

Questions # 44:

Anetwork engineer must configure a vPC on a pair of Cisco Nexus switches connected to a third-party load balancer. The connection must meet these requirements:

* The port channel must be negotiated with the load balancer via an open standards protocol.

* Traffic that is sent directly to the physical MAC address of the other peer switch must be forwarded locally by the receiving switch.

Which command set accomplishes these goals?

Options:

vpe domain 10 peer-gateway interface Eth1/1 channel-group 1 mode on

vpe domain 10 peer-switch interface Eth1/1 channel-group 1 mode on

vpe domain 10 peer-switch interface Eth1/1 channel-group 1 mode active

vpc domain 10peer-gateway interface Eth1/1 channel-group 1 mode active

Answer

Questions # 45:

A network architect must redesign a data center network based on OSPFv2. The network must perform fast reconvergence between directly connected switches. Which two actions must be taken to meet the requirements? (Choose two.)

Options:

implement a virtual link between the switches.

Set low OSPF hello and DEAD timers.

Enable BFD for failure detection.

Configure al links on AREA 0.

Use OSPF point-to point links only

Answer

C, E

Questions # 46:

Question # 46

Refer to the exhibit. An engineer monitors ingress traffic from Host-A and all traffic for VLAN 20 from Host-B Which configuration must be implemented to monitor and export traffic to Network Analyzer?

Question # 46

Options:

Option A

Option B

Option C

Option D

Answer

Questions # 47:

AN engineer is asked to modify an overridden policy by changing the number of FCNS database entries to 1500 and then generable a massage. What configuration will accomplish this task?

Question # 47 A)

Question # 47 B)

Question # 47 C)

Question # 47 D)

Options:

Option A

Option B

Option C

Option D

Answer

Questions # 48:

What occurs when running the command install deactivate

while a software maintenance upgrade is performed on a Cisco Nexus 9000 Series switch?

Options:

The current set of packages is committed.

The package is removed from the switch.

The package features for the line card are disabled.

The current upgrade stops.

Answer

Questions # 49:

Refer to the exhibit. A source is sending a multicast traffic stream to the receiver. How is the multicast traffic expected to flow through the network when it reaches a vPC peer?

Options:

The multicast traffic is not replicated to the ports that joined a multicast group (224.0.0.13) or the peer link. The multicast traffic stream flows from Agg-1 to Agg-2 over the M1-to-M2 peer link and forwards the traffic over Layer 4 to Access-2.

The multicast traffic is replicated to the ports that joined a given multicast group and the peer link. The multicast traffic stream flows from Agg-1 to Agg-2 over the M1-to-M2 peer link and forwards the traffic over Layer 4 to Access-2.

The multicast traffic is not replicated to the ports that joined a multicast group (224.0.0.13) or the peer link. The multicast traffic stream flows over the vPC link to ensure that orphan ports get the multicast stream in failure scenarios.

The multicast traffic is replicated to the ports that joined a given multicast group and the peer link. The multicast traffic stream flows over the peer link to ensure that orphan ports receive the multicast stream in failure scenarios.

Answer

Questions # 50:

What is the impact of upgrading the firmware version of the Cisco MDS 9200i Series Switch?