Pass the F5 LTM Specialist 301a Questions and answers with ExamsMirror

An LTM Specialist needs to configure a setup for antivirus scanning of HTTP traffic with an internet Contact adaption Protocol (ICAP) server.

Which two server type should be used? (Choose two.)

An LTM device an application that requires all connections to be secured via SSL The device must verify that request contain a specific cookie before allowing the request to be sent to the pool member.

Which virtual server type should an LTM Specialist configure on the LTM device?

An LTM Specialist needs to provide statistics regarding the round-trip time between the clients and the servers.

Which metric should be part of the analytics profile to provide that information?

A virtual server with SNAT automap enabled selects pool member 10.20.0.10.443 for the server-side flow. The client side flow source IP is 192.168.0.10 .

Which source IP should be expected in the server-side connection?

An LTM Specialist needs to load balance an application using an LTM device to meet the requirements:

The application servers do NOT Support SSL, but client access to the application should be secured.

Multiple requests from the same client should be sent to the same pool member.

All pool members will have roughly the same processing power, and traffic should be distributed evenly.

The LTM device is NOT the pool members' default gateway.

which configuration should the LTM Specialist.

An LTM Specialist plans to enable connection mirroring for a virtual server in an HA environment.

What must the LTM Specialist consider before implementing the configuration change?

An LTM Specialist is removing some of the load off an existing cluster by adding a adding a third BIG-IP

device to the device group. The new device can deliver twice the performance of the other two devices.

The LTM Specialist needs to make sure that the BIG-IP device with the highest available capacity is

always selected to take over a traffic group in the event of a failover.

Which failover method is most appropriate?

In an iApp, which configuration protects against accidental changes to an application Services configuration?

An LTM Specialist configures a new virtual server with a single pool member. The LTM Specialist has NOT defined a health monitor for the pool, pool member or node.

What is the status of the virtual server?

Refer to the exhibit.

An LTM Specialist has multiple SNAT and virtual server objects configured as in the bigip.conf shown.

The LTM Specialist tests a connection from a client with. IP 172.163.31.11 to 192.168.0.100:80.

Which two objects will show an increase in Local Traffic statistics connections?