Spring Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = getmirror

Pass the Nokia SRC Certification 4A0-104 Questions and answers with ExamsMirror

Practice at least 50% of the questions to maximize your chances of passing.
Exam 4A0-104 Premium Access

View all detail and faqs for the 4A0-104 exam

Go to Exam

684 Students Passed

84% Average Score

90% Same Questions
Viewing page 2 out of 9 pages
Viewing questions 11-20 out of questions
Questions # 11:

Which of the following conditions are necessary in order for service labels to be signaled between two PE routers? (Choose 3)

Options:

A.

LDP must be enabled on both PE routers.

B.

RSVP must be enabled on both PE routers.

C.

Traffic engineering must be enabled in the IGP.

D.

The VC-ID must match between the two PE routers in both directions.

E.

The transport tunnel must be operationally up between the two PE routers in both directions.

F.

The SDP ID must match between the two PE routers in both directions.

Questions # 12:

What needs to be configured before a SAP appears? (Choose 2)

Options:

A.

Configuring the physical port in access mode.

B.

Configuring the physical port in network mode.

C.

Enabling the port using the no shutdown command.

D.

Ports are enabled by default, thus no need to use the no shutdown command.

Questions # 13:

Which service type would be used to provide a bi-directional Layer 2 connection of TDM circuits over an IP/MPLS network?

Options:

A.

A-pipe

B.

E-pipe

C.

I-pipe

D.

F-pipe

E.

C-pipe

Questions # 14:

Which of the following statements is FALSE regarding 6VPE?

Options:

A.

Multiple MP-BGP sessions are required to carry VPN-IPv4 and VPN-IPv6 routes.

B.

PE routers must support both IPv4 and IPv6 addresses; customer routers can use either one

C.

In 6VPE, MP-BGP is used to advertise IPv6 prefixes and the associated VPRN label.

D.

In 6VPE, the provider core routers are IPv6-unaware.

E.

All of the above statements are true.

F.

All of the above statements are false.

Questions # 15:

Which of the following SAPs willforward tagged frames with an outer VLAN tag of 200? (Choose 3)

Options:

A.

sap 1/1/1

B.

sap 1/1/1:*

C.

sap 1/1/1:*.0

D.

sap 1/1/1:0*

E.

sap 1/1/1:200.*

F.

sap 1/1/1:300:200

Questions # 16:

Click on the exhibit button below.

Question # 16

Assuming the customer only needs to monitor traffic from PE3 to the customer site, what two items are missing in the configuration of PE5, the Alcatel-Lucent 7750 Service Router in the Head Office? (Assume that the IP/MPLS network structure between the local and remote PEs is in place.)

Options:

A.

The mirror destination configuration on PE5 is missing the "remote-source" command.

B.

There needs to be a mirror source configuration on PE5 with the "remote-source" command.

C.

This is not possible since the protocol analyzer is located at the Central Office. It needs to be at the customer site.

D.

There needs to be a configuration command to put sap 1/1/3 on the mirror destination of PE5.

E.

There needs to be a configuration command to put sap 1/1/3 on the mirror source of PE5

Questions # 17:

In a Layer 2 VPN service, the FCS is stripped when a customer packet arrives at the ingress PE and regenerated on egress.

Options:

A.

TRUE

B.

FALSE

Questions # 18:

Which of the following are characteristics of an IES service? (Choose 2)

Options:

A.

A virtual routing/forwarding table is created per IES service.

B.

Only one IES service can be created for a single customer ID.

C.

More than one IP interface can be created within a single IES service.

D.

All IP interfaces created within the same IES service belong to the same customer

Questions # 19:

Which of the following best describes an SDP?

Options:

A.

Acts as a logical way to direct traffic from one SAP to another on a single node.

B.

Acts as a logical way to direct traffic from one service to another on a single node.

C.

Acts as a logical way to direct traffic from one access port to another.

D.

Acts as a logical way to direct traffic from services on one router to services on another.

Questions # 20:

A SAP configured in the form of 1/1/1:0/32 would be used for which type of VPWS?

Options:

A.

A-pipe

B.

C-pipe

C.

E-pipe

D.

F-pipe

Viewing page 2 out of 9 pages
Viewing questions 11-20 out of questions
TOP CODES

TOP CODES

Top selling exam codes in the certification world, popular, in demand and updated to help you pass on the first try.

2V0-11.25
ADM-201
Agentforce-Specialist
CMMC-CCP
Data-Cloud-Consultant
PDI
PSE-Strata-Pro-24
Secure-Software-Design
Sharing-and-Visibility-Architect
Workday-Pro-Integrations
ZDTA