Pass the Riverbed RCPE-CP-WO 830-01 Questions and answers with ExamsMirror

What parameters are required to add a new Steelhead appliance on the CMC appliance? (Select 2)

In a new in-path deployment, connections are listed as pass-through on the branch office Steelhead appliance. Which of the following is the likely cause of the problem?

1) Pass-through rule preventing optimization

2) Server-side Steelhead appliance is down

3) Satellite proxy not copying auto-discovery probes

4) Asymmetric routing is detected for the client/server flow

5) Duplex mismatch on WAN or LAN interface

How many failover buddies can be configured for a single Interceptor?

Which of the following configuration policies are supported on the CMC appliance? (Select 4)

Your Steelhead appliance deployment includes users accessing the Internet from branch offices with the traffic being back-hauled to the data center before going out to the Internet. However, HTTP latency optimization does not appear to be very effective, and in certain cases, is slower than without optimization. What settings might help with this Internet-bound traffic?

If using Fixed-target rules, what Steelhead specific probe options are associated with the SYN packet?

Refer to the exhibit.

A connection times out when Client41 and Client42 attempt to either establish an HTTP session to Server31 or an FTP connection to Server32 after not connecting to them for some time. The very next attempt to connect to these services done immediately after the failure seems to work correctly. The clients are able to ping both servers and no access-lists are configured on the routers. SH3 uses the IP address of R3f0 as its default gateway. Upon powering off SH3 and SH4, the problem goes away even for first connection and everything works normally (even after not connecting for extended periods of time). Which of the following are likely to correct this problem?

A customer is reporting higher than normal CPU utilization on certain routers in their network. Looking at their Steelhead appliance logs, they see “intercept/localkernel/icore.c:1463] nat_check: SYN packet for already NAT'd connection 100.100.100.33:1611 -> 100.200.200.32:80 ==> 100.201.201.25:7801”. All connections are showing up optimized but the logs persist. Given the exhibit,

what is the likely problem?

How many in-path rules will a WAN-initiated (i.e. SYN packet arrives at a WAN port of an In-path interface) single connection match? Assume no packet ricochet occurs (i.e. the SYN travels through the Interceptor appliance once).

When registering a Steelhead appliance to the CMC appliance, which of the following options are available? (Select 4)