BICSI Installer 2 - Copper Exam (INSTC_V8) Practice Test

Questions # 21:

Unqualified workers must stay AT LEAST ____ from exposed energized conductors operating at 300 to 50,000 V.

Options:

0.3 m (1')

3 m (10')

15 m (50")

30 m (100')

Questions # 22:

You are terminating a category 3 cable. What is the maximum permissible amount of untwisting?

Options:

25 mm (1")

38 mm (1.5")

75 mm (3")

100 mm (4")

Questions # 23:

When routing conduits through a fire-rated floor assembly, which principle BEST ensures compliance with fire code requirements?

Options:

Oversizing the conduit to reduce cable friction

Filling any gap around the conduit with an approved firestop system

Installing a second parallel conduit for redundancy

Placing a service loop inside the conduit above the floor

Questions # 24:

Which of the following makes the biggest impression on a customer when you are communicating via email?

Options:

Choice of words

Body language

Tone of voice

Questions # 25:

What is the maximum allowable horizontal cable length?

Options:

10 m (33 ')

30 m (100')

50 m (164')

90 m (295')

Questions # 26:

Which statement is TRUE about support systems for horizontal cabling according to BICSI and TIA/EIA standards?

Options:

J-hooks are generally prohibited except in buildings over four stories.

Cable supports must be placed at intervals not exceeding 1.5 m (5 ft).

Lashing cables to electrical conduits is acceptable in open ceilings.

The support system must integrate with the building’s water piping.

Questions # 27:

Which of the following is used to perform continuity and length tests for coaxial cable?

Options:

TDR (Time domain reflectometer) with an adapter

OLTS (optical loss test set)

VFL (visual fault locator)

OTDR (optical time domain reflectometer

Questions # 28:

Which term describes using an LC connector on a fiber cable for the main cable plant side, and SC connector for the equipment side, in the same patch panel adapter?

Options:

Transitional attenuation

Mode mixing

Hybrid adapter coupling

Duplex bridging

Questions # 29:

A third 90-degree bend may be permitted in a conduit run if one of the bends is located within ____ of the cable feed end?

Options:

300 mm (12")

375 mm (15")

450 mm (18")

483mm (19")

Questions # 30:

How many cycles are in 10Hz?

Options:

Viewing page 3 out of 5 pages

Viewing questions 21-30 out of questions

Spring Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = getmirror

Pass the BICSI Cabling Installation INSTC_V8 Questions and answers with ExamsMirror

Exam INSTC_V8 Premium Access

Options:

Options:

Options:

Options:

Options:

Options:

Options:

Options:

Options:

Options:

TOP CODES