Pass the Cisco CCNP Enterprise 300-410 Questions and answers with ExamsMirror

Refer to the exhibit The enterprise users fail to authenticate with the TACACS server when a direct fiber link fails between RB and RD The NOC team observes

Users connected on AS65201 fail to authenticate with TACACS server 192 168 1 1

Users connected on AS65101 successfully authenticate with TACACS server 192 168 1 1

All AS65101 and AS65201 users are configured to authenticate with the TACACS server

Which configuration resolves the issue?

A)

B)

C)

D)

What is a function of the IPv6 DHCP Guard feature for DHCP messages?

What is a function of IPv6 Source Guard?

Refer to the exhibit.

Routers R1, R2, R3, and R4 use EIGRP However, traffic always prefers R1 to R5 backup links in nonfailure scenarios. Which configuration resolves the issue?

A)

B)

C)

D)

Refer to the exhibit.

An engineer configured BGP between routers R1 and R3 The BOP peers cannot establish neighbor adjacency to be able to exchange routes. Which configuration resolves this issue?

An engineer configured access list NON-CISCO in a policy to influence routes

What are the two effects of this route map configuration? (Choose two.)

Refer to the exhibit.

An engineer wanted to set a tag of 30 to route 10 1.80.65/32 but it failed How is the issue fixed?

Refer to the exhibit.

BGP and EIGRP are mutually redistributed on R3, and EIGRP and OSPF are mutually redistributed on R1. Users report packet loss and interruption of service to applications hosted onthe 10.1.1.0724 prefix. An engineer tested the link from R3 to R4 with no packet loss present but has noticed frequent routing changes on R3 when running the debug ip route command. Which action stabilizes the service?

Which feature drops packets if the source address is not found in the snooping table?

Which IGPs are supported by the MPLS LDP autoconfiguration feature?

Refer to Exhibit.

A network administrator added one router in the Cisco DNA Center and checked its discovery and health from the Network Health Dashboard. The network administrator observed that the router is still showing up as unmonitored. What must be configured on the router to mount it in the Cisco DNA Center?

An engineer configured a Cisco router to send reliable and encrypted notifications for any events to the management server. It was noticed that the notification messages are reliable but not encrypted. Which action resolves the issue?

An engineer is troubleshooting on the console session of a router and turns on multiple debug commands. The console screen is filled with scrolling debug messages that none of the commands can be verified if entered correctly or display any output. Which action allows the engineer to see entered console commands while still continuing the analysis of the debug messages?

Refer to the exhibit.

A network administrator is using the DNA Assurance Dashboard panel to troubleshoot an OSPF adjacency that failed between Edge_NYC interface GigabitEthernet1/3 with Neighbor Edge_SNJ. The administrator observes that the neighborship is stuck in exstart state. How does the administrator fix this issue?

Refer to Exhibit.

The network administrator configured the branch router for IPv6 on the E0/0 interface. The neighboring router is fully configured to meet requirements, but the neighbor relationship is not coming up. Which action fixes the problem on the branch router to bring the IPv6 neighbors up?