Summer Certification Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = getmirror

Pass the Cisco CCNP Enterprise 300-410 Questions and answers with ExamsMirror

Practice at least 50% of the questions to maximize your chances of passing.

Exam 300-410 Premium Access

View all detail and faqs for the 300-410 exam

Go to Exam

731 Students Passed

84% Average Score

98% Same Questions

Viewing page 6 out of 13 pages

Viewing questions 76-90 out of questions

Questions # 76:

Refer to the following output:

Router#show ip nhrp detail

10.1.1.2/8 via 10.2.1.2, Tunnel1 created 00:00:12, expire 01:59:47

TypE. dynamic, Flags: authoritative unique nat registered used

NBMA address: 10.12.1.2

What does the authoritative flag mean in regards to the NHRP information?

Options:

It was obtained directly from the next-hop server.

Data packets are process switches for this mapping entry.

NHRP mapping is for networks that are local to this router.

The mapping entry was created in response to an NHRP registration request.

The NHRP mapping entry cannot be overwritten.

Questions # 77:

An engineer configured a leak-map command to summarize EIGRP routes and advertise specifically loopback 0 with an IP of 10.1.1.1.255.255.255.252 along with the summary route. After finishing configuration, the customer complained not receiving summary route with specific loopback address. Which two configurations will fix it? (Choose two.)

Question # 77

Options:

Configure access-list 1 permit 10.1.1.0.0.0.0.3.

Configure access-list 1 permit 10.1.1.1.0.0.0.252.

Configure access-list 1 and match under route-map Leak-Route.

Configure route-map Leak-Route permit 10 and match access-list 1.

Configure route-map Leak-Route permit 20.

Questions # 78:

Which Cisco VPN technology can use multipoint tunnel, resulting in a single GRE tunnel interface on the hub, to support multiple connections from multiple spoke devices?

Options:

DMVPN

GETVPN

Cisco Easy VPN

FlexVPN

Questions # 79:

Which statement about IPv6 RA Guard is true?

Options:

It does not offer protection in environments where IPv6 traffic is tunneled.

It cannot be configured on a switch port interface in the ingress direction.

Packets that are dropped by IPv6 RA Guard cannot be spanned.

It is not supported in hardware when TCAM is programmed.

Questions # 80:

Which security feature can protect DMVPN tunnels?

Options:

IPsec

TACACS+

RTBH

RADIUS

Questions # 81:

What is the role of a route distinguisher via a VRF-Lite setup implementation?

Options:

It extends the IP address to identify which VFP instance it belongs to.

It manages the import and export of routes between two or more VRF instances

It enables multicast distribution for VRF-Lite setups to enhance EGP routing protocol capabilities

It enables multicast distribution for VRF-Lite setups to enhance IGP routing protocol capabilities

Questions # 82:

Refer to the exhibit.

Question # 82

Which control plane policy limits BGP traffic that is destined to the CPU to 1 Mbps and

ignores BGP traffic that is sent at higher rate?

Options:

policy-map SHAPE_BGP

policy-map LIMIT_BGP

policy-map POLICE_BGP

policy-map COPP

Questions # 83:

Which protocol does MPLS use to support traffic engineering?

Options:

Tag Distribution Protocol (TDP)

Resource Reservation Protocol (RSVP)

Border Gateway Protocol (BGP)

Label Distribution Protocol (LDP)

Questions # 84:

Refer to the exhibit.

Question # 84

In which circumstance does the BGP neighbor remain in the idle condition?

Options:

if prefixes are not received from the BGP peer

if prefixes reach the maximum limit

if a prefix list is applied on the inbound direction

if prefixes exceed the maximum limit

Questions # 85:

Refer to the exhibit.

Question # 85

A network engineer for AS64512 must remove the inbound and outbound traffic from link A during maintenance without closing the BGP session so that there ............ a backup link over link A toward the ASN. Which BGP configuration on R1 accomplishes this goal?

Question # 85

Options:

Option A

Option B

Option C

Option D

Questions # 86:

Which label operations are performed by a label edge router?

Options:

SWAP and POP

SWAP and PUSH

PUSH and PHP

PUSH and POP

Questions # 87:

Refer to the exhibit.

Question # 87

After redistribution is enabled between the routing protocols; PC2, PC3, and PC4 cannot reach PC1. Which action can the engineer take to solve the issue so that all the PCs are reachable?