Pass the Cisco CCNP Enterprise 300-410 Questions and answers with ExamsMirror

Which command displays the IP routing table information that is associated with VRF-Lite?

R2 has a locally originated prefix 192.168.130.0/24 and has these configurations:

What is the result when the route-map OUT command is applied toward an eBGP neighbor R1 (1.1.1.1) by using the neighbor 1.1.1.1 route-map OUT out command?

Refer to the exhibit.

During troubleshooting it was discovered that the device is not reachable using a secure

web browser. What is needed to fix the problem?

Refer to Exhibit.

Which statement about redistribution from BGP into OSPF process 10 is true?

Drag and drop the MPLS VPN concepts from the left onto the correct descriptions on the right.

Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right.

A network engineer needs to verify IP SLA operations on an interface that shows on indication of

excessive traffic.

Which command should the engineer use to complete this action?

Refer to the exhibit. an engineer is trying to get 192.168.32.100 forwarded through 10.1.1.1, but it was forwarded through 10.1.1.2. What action forwards the packets through 10.1.1.1?

Drag and drop the MPLS VPN device types from me left onto the definitions on the right.

Refer to the exhibit.

ISP 1 and ISP 2 directly connect to the Internet. A customer is tracking both ISP links to

achieve redundancy and cannot see the Cisco IOS IP SLA tracking output on the router console. Which command is missing from the IP SLA configuration?

Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected through a common fiber?

Refer to the exhibit.

AAA server 10.1.1.1 is configured with the default authentication and accounting settings, but the switch cannot communicate with the server Which action resolves this issue?

Refer to the exhibit.

R2 is a route reflector, and R1 and R3 are route reflector clients. The route reflector learns the route to 172.16.25.0/24 from R1, but it does not advertise to R3. What is the reason the route is not advertised?

Which two methods use IPsec to provide secure connectivity from the branch office to the headquarters office? (Choose two.)

An engineer configured a company’s multiple area OSPF head office router and Site A cisco

routers with VRF lite. Each site router is connected to a PE router of an MPLS backbone.

After finishing both site router configurations, none of the LSA 3,4 5, and 7 are installed at Site A router. Which configuration resolves this issue?